features low profile package ideal for automated placement glass passivated chip junctions ultrafast reverse recovery time low switching losses, high efficiency high forward surge capability high temperature soldering 260 /10 seconds at terminals component in accordance to rohs 2002/95/1 and weee 2002/96/ec major ratings and characteristics mechanical date case: jedec do-214aa molded plastic body over glass passivated chip terminals: solder plated, solderable per j-std-002b and jesd22-b102d polarit y : laser band denotes cathode end 2.0 a v rrm 50 v to 1000 v i fsm 50 a t rr 50 ns , 75 ns 1.0 v , 1.3 v , 1.7 v t j max. i f(av) v f 150 c y maximum ratings & thermal characteristics (t a = 25 c unless otherwise noted) note 1: mounted on p.c.b. with 0.28 x 0.28? (7.0 x 7.0mm) copper pad areas. electrical characteristics (t a = 25 c unless otherwise noted) note 2: pulse test:300 s pulse width,1% duty cycle. pf t rr 75 v f 1.7 v 1.0 1.3 5 ns i r a operating junction and storage temperature range t j , t stg ?55 to +150 symbol us2j~us2m unit 50 peak forward surge current 8.3 ms single half sine-wave superimposed on rated load i fsm 50 a thermal resistance from junction to lead (1) r jl 25 / w 800 1000 v maximum average forward rectified current i f(av) 2.0 a 560 700 v maximum dc blocking voltage v dc 50 100 200 400 600 800 1000 v maximum rms voltage v rms 35 70 140 280 420 us2k us2m unit maximum repetitive peak reverse voltage v rrm 50 100 200 400 600 symbol us2a us2b us2d US2G us2j c j j t a =25 items instantaneous forward voltage reverse recovery time us2a~us2d US2G items 50 15 typical junction capacitance reverse current test conditions i f =2.0 a (2) v r =v dc t a =100 i f = 0.5 a , i r = 1.0 a , i rr = 0.25 a 4.0 v ,1mhz http://www.trr-jx.com us2a-us2m surface mount ultra fast rectifiers
characteristic curves (t a =25 unless otherwise noted) http://www.trr-jx.com us2a-us2m surface mount ultra fast rectifiers
package outline notice product is intended for use in general electronics applications. product should be worked less than the ratings; if exceeded, may cause permanent damage. or introduce latent failure mechanisms. the absolute maximum ratings are rated values and must not be exceeded during operation. the following are the general derating methods you design a circuit with a device. i f(av) : we recommend that the worst case current be no greater than 80% . i fsm : this rating specifies the non-repetitive peak current. this is only applied for an abnormal operation, which the general during the lifespan of the device. t j : derate this rating when using a device in order to ensure high reliability. we recommend that the device be used at a t j of below 125c. trr is registered trademark of rising-sun technology. rising-sun te chnology reserves the right to make changes to any product i n this specification to improve reli ability,functional characterist ics,or design without notice. rising-sun technology does not assure any liability arising out of the applic ations or any product descr ibed in this specificat ion. rising-sun technology advises customers to obtain the latest vers ion of the device information before placing orders to verify that the required information is current. http://www.trr-jx.com us2a-us2m surface mount ultra fast rectifiers
|
